Bridge Work Will Limit Access to Boat Launch, Cause Traffic Tie Ups
Access to the Irwin Run Canoe Launch will be extremely limited next week as work continues on the Irwin Run Bridge, so boaters are encouraged to use alternate launches.
Next Wednesday, the contractor will set the second half of the pre-cast, reinforced concrete bridge. This involves 12 wide loads carrying sections of the bridge traveling from Ridgway to the bridge site. This is scheduled to start at 6 a.m. and will continue until late evening.
Flaggers will control traffic and motorists will be stopped as each section is unloaded. Delays may occur along routes 219, 948 and 3002. Traffic will be stopped on Route 3002 as each section arrives at the bridge site.
All work is weather dependent. PennDOT expects the project to be finished in September.
Next Wednesday, the contractor will set the second half of the pre-cast, reinforced concrete bridge. This involves 12 wide loads carrying sections of the bridge traveling from Ridgway to the bridge site. This is scheduled to start at 6 a.m. and will continue until late evening.
Flaggers will control traffic and motorists will be stopped as each section is unloaded. Delays may occur along routes 219, 948 and 3002. Traffic will be stopped on Route 3002 as each section arrives at the bridge site.
All work is weather dependent. PennDOT expects the project to be finished in September.
.jpg)
Comments